Metal Injection Molding | FloMet, LLC Logo

  
Search:

Metal Injection Molding Components

Metal Injection Molding | FloMet, LLC Locations


Where is FloMet?

FloMet is located in DeLand, Florida at 810 Flightline Blvd. The facility is in the DeLand Air/Tech Park where Flightline Blvd. intersects US Hwy. 92. US Hwy. 92 is also known as International Speedway Blvd. DeLand is approximately 20 miles west, southwest of Daytona Beach International Airport and approximately 40 miles east, northeast of Orlando International Airport.

From the Daytona Beach Airport
Take the airport exit and make a left turn onto International Speedway Blvd (US Hwy. 92) and travel approximately 20 miles west to Deland. FloMet is located on your right, at the intersection of US Hwy. 92 and Flightline Blvd., approximately 2 miles inside the Deland city limits. FloMet’s facility is marked on the map below with a hand pointing to the DeLand vicinity.

From the Orlando International Airport
Take the airport exit onto the eastbound Beeline Expressway toll road (State Road 528) to the Greenway toll road (State Road 417) toward Sanford (North) to I-4 toward Daytona Beach (East). Travel on I-4 east until you reach exit 118. Exit 118 is marked for State Road 44 and New Smyrna Beach. When exiting at exit 118 make a right to go back over I-4. Travel 2.4 miles to the third traffic light which is the intersection of Kepler Road and State Road 44. Make a right onto Kepler Road and travel 2.6 miles until Kepler Road intersects US Hwy. 92 (also known as International Speedway Blvd). Make a left onto US 92 and travel 1.5 miles west. FloMet is located on your right, on Flightline Blvd at the intersection of US 92. FloMet’s facility is marked on the map  below with a hand pointing to the DeLand vicinity.


Click For a Bigger Printable Maps

 

 

Case Study # 2
Case Study #2: DRO Housing
Component: DRO Housing
Challenge:  This defibrillating resonating oscillator was growing in volume requirements. Traditionally machined because of low quantities, challenges to reduce cost while maintaining precision, hermiticity, and the same co-efficiency of thermal expansion were presented to FloMet.
Solution: A CTE tailored Fe Ni feedstock was developed for the application. The customer and FloMet worked together to create a part with minimum weight. No machining, incorporation of additional features that had been separate assembly parts attained a superior level of Tekna Seal finished hermeticity.
Click here for more info


Home | About FloMet | Virtual Tour | Technology | Materials | Part & Tool Design
Metal Injection Molding Case Studies | Published Papers | Accolades | News | File Transfers 
Locations | Ask the Tech | Contact Us

 

 
       

Copyright 2003 - FloMet - All Rights Reserved